How To Apply Using Professional LED Light

Before You Begin

Tips

For ease of application and curing, we recommend performing the following steps first on your four finger nails. Once your four finger nails have been cured under the light, you can repeat each step for your thumb nail.

Step 1

Preparation

Brush Prep MAX ADHESION SANITIZER on to clean nails. This essential first step will remove any residue from the nails, to aid effective application of your care, colour and finish products for a long-lasting result.

Step 2a

Care and Colour

Apply a thin coat of Structure BASE COAT GEL. Cure under the Professional LED Light for 30 seconds.

Step 2b

Care and Colour

Apply a thin coat of your choice of colour from the LED Gel Polish range. Cure under the Professional LED Light for 45 seconds. Apply your second coat of colour and cure again under the Professional LED Light for another 45 seconds.

Step 2c

Care and Colour

Apply a thin coat of Brilliance SEAL & SHINE TOP COAT GEL. Cure under the Professional LED Light for 45 seconds.

Step 3

Finish

Remove the tacky residue with Purify PRE & POST APPLICATION CLEANSER.

How to Remove

Before You Begin

Tips

For ease of removal, prepare ten squares of foil, each about 5cm square, before you begin this stage.

Step 1

Preparation

Buff the surface of the nail to break the top coat seal.

Step 2a

Removal

Saturate a cotton ball with Erase GEL NAIL POLISH REMOVER. Place the cotton ball onto the nail and wrap in aluminium foil.

Step 2b

Removal

Leave the nail wrapped in foil for 10-15 minutes.

Step 2c

Removal

Unwrap the nail and slide the cotton ball off. Using an orange stick, gently scrape off any remaining colour.

Step 3

Finish

Massage Revitalise NOURISHING CUTICLE OIL into the cuticle and natural nail.